Home » Repair Steering Gear Port and STBD KT Bima I PT Seloko Batam Shipyard

Repair Steering Gear Port and STBD KT Bima I PT Seloko Batam Shipyard

IDENTIFICATION RESULT RESUL

1. Steering gear port and STBD systems cannot be commanded from the bridge.

2. Angular designation on the rudder Port and STBD is inconsistent


SOLUTION AND ACTION TAKEN

1. Steering gear port and STBD systems cannot be commanded from the bridge.

 

Action

 

Result

Solution

Port

STBD

1

Checking the signal cable between the steering wheel to the Schottel steering control, the system uses a 10 Volt voltage signal.

No voltage signal

No voltage signal

Resolder on the power cable of the Steering Amplifier Module and Rotation Control Module, can solve the problem.

10 VDC voltage signal is ready to go to the steeing wheel.

2

Check the Schottel control panel wiring.

Wiring is still neat

Wiring changes a lot

 

3

Checking 27 VDC power to all module cards.

Soldering the wires to the power card and Rotation Steering Amplifier Module Control Module disconnected

Soldering the wires to the power card and Rotation Steering Amplifier Module Control Module disconnected

Resolder on the power cable of the Steering Amplifier Module and Rotation Control Module, can solve the problem.

Supply voltage for both modules is resolved.

1.     2. Angular designation on the rudder Port and STBD is inconsistent

 

Action

Result

Solution

Port

STBD

1

Rudder angle sensor checks

Rudder angle connector is loose

Good condition

Modify a connector by direct soldering the signal cable to the connector pins.(Port Side)

2

Check the signal to the Rudder Indicator

Unstable signal, indicating hunting

No indication of the rudder indikator

          Port side: Resoldering the power module of the Steering Amplifier Module and Rotation Control Module, can solve this problem.

          STBD Side: Faulty signal cable connection place on the panel terminal. Restoring the proper connection, solves this problem.


CONCLUSION

1.    1. Steering gear system is working properly, it can be ordered from the bridge.

2. Rudder angle on the indicator has appeared, although not quite right. Angle accuracy will be made when the ship is moving.


DOCUMENTATION

Repair Steering Gear Port and STBD KT Bima I PT Seloko Batam Shipyard

Repair Steering Gear Port and STBD KT Bima I PT Seloko Batam Shipyard

Repair Steering Gear Port and STBD KT Bima I PT Seloko Batam Shipyard

Repair Steering Gear Port and STBD KT Bima I PT Seloko Batam Shipyard

Repair Steering Gear Port and STBD KT Bima I PT Seloko Batam Shipyard





Leave a Reply

Your email address will not be published. Required fields are marked *